![]() If you change the length of cue 22 to eight seconds and then run the cue sequence again, QLab will start cue 21 and cue 22, wait eight seconds, and then start cue 23. Three seconds later, start cue 22, then,.Start cue 21 and cue 22 immediately, then,.When cue 21 is standing by and you press, QLab will: Cue 22 (“level down music”) has a pre-wait of 3 seconds, a duration of 2 seconds, and is set to auto-follow. Cue 21 (“intro music”) is set to auto-continue with no post-wait. This screen shot shows a cue sequence made up of three cues connected with one auto-continue and one auto-follow. Auto-followĪ cue set to auto-follow will cause the following cue to start after the initial cue has completed. To remove the auto-continue, select Do not continue from the pop-up menu. A straight arrow ( ) will appear in the far-right column of that cue’s row in the cue list. Click on the Continue pop-up menu in the bottom-left corner and choose Auto-continue. ![]() To set a cue to auto-continue, select that cue and then look in the Basics tab of the inspector.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |